Publicité
Wheel spin takes place automatically when the guard is lowered, or can be triggered
by pressing the START key with the guard lowered.
A special safety device stops rotation if the guard is raised during the spin; in this case,
the "A Cr" message is displayed.
WARNING
Do not operate the machine without the guard and/or if the safety device has been
tampered with.
WARNING
Never raise the guard before the wheel has come to a stop.
WARNING
If the wheel keeps spinning permanently due to a fault on the machine, switch off
the machine using the main switch or disconnect the plug from the power supply
board (emergency stop) and wait until the wheel stops before raising the guard.
SELECTION OF ADHESIVE WEIGHTS
The machine makes it possible for the operator to select where the adhesive weight
should be applied based on his needs.
To select this configuration, proceed as described below:
• press either of the two keys
the
key. This selects the service programme 89 shown on the left display.
The flashing "Ent" message will appear on the right display;
- press the
The message ALU will appear on the left display, whereas the message H.XX will
appear on the right display, where XX indicates the selection of the Adhesive Weight
application enabled on the machine;
• the
key can be used to change this configuration to H3, H6 or H12;
• press
to confirm the selection made and exit the function;
78
WHEEL SPIN (with guard)
APPLICATION POSITION
key to confirm.
and then, within two seconds, press
Operator's manual MT 3100 - MT3200
Publicité
