Publicité
i
nstalling the wheel guard with the corresponding Mounting
- Install the bush (A, fig. 4) on the pivot (B, fig. 4). While doing this, ensure that the
groove on the pivot is aligned with the pin in the bush;
- Fasten the tube on the pivot using the M12 screw supplied.
- insert the metal tube (D, Fig. 4a) into the two plastic guard front holes (C, Fig. 4a);
- couple the guard to the rear side of the tube by inserting it into the correct position
with snap-in coupling (E, Fig. 4a);
- secure the wheel guard by tightening the screw provided (F, Fig. 4a).
The machine is to be fixed to the ground if:
- it does not have the accessory triangular foot;
- if it does have the accessory triangular foot but is going to be used with wheels
heavier than 50Kg. In such a case the triangular foot will have to be removed in order
to fix the front bracket.
60
4
f
ixing the Machine to the ground
5
(f
. 6)
ig
600
Operator's manual MT 3100 - MT3200
(f
. 4)
ig
4a
1000
1000
5a
Publicité
