Publicité
- Rotate the wheel until you reach the position indicated by the illuminated central
elements of the position indicator;
- make a double mark on the outer side of the tyre at the 12 o'clock position with a
piece of chalk. If the screen indicates that the tyre should be switched around on the
rim, make a double mark on the inner side using a piece of chalk. The user can switch
from the "with reversal" to the "without reversal" mode by pressing the
- press the
- disassemble the wheel from the wheel balancer;
- turn the tyre (and reverse its mounting if necessary) on the rim until the double chalk
mark is in line with the valve;
- remount the wheel on the wheel balancer;
- press the
- perform a spin.
When the spin is over the optimisation programme has been completed and the weights
to be applied to balance the wheel are displayed.
If an error that may affect the end result occurs, the machine indicates it by temporar-
ily displaying the "E 6" message. The procedure can now be repeated.
- The "OUT 2" message can be displayed at the end of the first spin. In this case it is
advisable to exit the programme by pressing the key:
necessary for balancing the wheel are displayed. The execution of the programme
is interrupted, thus not achieving the moderate improvement of the end results. By
pressing the
- At the end of the first spin the instruction that the tyre is to be mounted on the rim in
the reverse direction may appear. If you do not intend to reverse the tyre or if doing
so is impossible, press the
for completing the programme without reversing the tyre.
Operator's manual MT 3100 - MT3200
button;
key to confirm the performed rotation;
key the optimisation procedure can be continued.
key and the machine will provide the instructions
opt 3
s
pecial cases
the values of the weights
key;
93
Publicité
