Publicité
In the event of failure of the automatic measuring system and in the version with
internal manual sensor, the geometrical data can be entered using the keypad:
- Press the
button;
- measure the width of the rim using the provided calliper (Fig. 11);
- modify the width value displayed by pressing the keys
number is set. The width can be set in millimetres or the values already set can be
converted from inches to millimetres by pressing the
- values set previously can be increased or decreased quickly by keeping the keys
pressed;
- press the
button to confirm the previous value and set the machine for diameter
data entry;
- read the rated rim diameter value on the tyre;
- modify the displayed diameter value by pressing the
read number is set. The diameter can be set in millimetres or the values already set
can be converted from inches to millimetres by pressing the
seconds;
- press the
button to confirm the previous value and set the machine for distance
data entry;
- bring the distance measuring arm into contact with the inner side of the rim (Fig.
10/10a);
- read the wheel/body distance on the rule (A, Fig.11b);
76
M
anual wheel data entrY
until the desired
button for five seconds;
buttons until the
11b
Operator's manual MT 3100 - MT3200
button for five
Publicité
