Publicité
Once the selection has been made, the machine will indicate whether it is convenient to
proceed with the programme. To do this the machine will flash the following message:
• "YES OPT" if it is worth executing the programme;
• "NO OPT" if it is not.
Press the
key to exit the programme and return to the DYN environment;
When the procedure is called up, the following appears on the left display: "OP.1".
- Move valve to 12 o'clock;
- confirm the operation by pressing the
- Rotate the wheel until you reach the position indicated by the illuminated central
elements of the position indicator;
- mark the 12 o'clock position on the outer tyre side using a piece of chalk;
- press the
button;
- if the
key is pressed now, the system temporarily exits from the OPT programme
(to return, repeat the initial OPT programme activation procedure);
- disassemble the wheel from the wheel balancer;
- rotate the tyre on the rim until the previously done chalk mark is in line with the
valve (180° rotation);
- remount the wheel on the wheel balancer;
- turn the wheel until the valve is in the 12 o'clock position;
- press the
button;
- perform a spin.
The improvement preview can be displayed before continuing with the last phase of the
optimisation procedure. If the improvement is considered insufficient or if no further
significant improvements can be achieved, press the
Proceed as follows to display the improvement that can be achieved:
- press the
button once: the actual unbalance values of the wheel as currently
mounted on the wheel balancer are now shown on the displays;
- press the
button again: the unbalance values indicated on the displays are the
values that can be achieved by continuing with the last phase of the optimisation
procedure;
- when the
last phase of the OPT programme.
92
button is pressed for the third time, the machine prepares for the
opt 1
key.
opt 2
Operator's manual MT 3100 - MT3200
key to exit.
Publicité
