Publicité
WHEEL DATA ENTRY VERSION WITH
AUTOMATIC SENSOR FOR WHEEL BALANCERS
WITHOUT EXTERNAL SENSOR
The machine allows for the diameter and distance values to be entered automatically;
the width value can be entered using the keypad.
- Move the automatic measuring arm (A, Fig. 7) so it comes into contact with the inner
side of the rim as shown in Fig. 10/10a.
Take great care to position the arm correctly so as to ensure accurate data reading.
- Keep the arm in contact with the rim until the machine has acquired the wheel's
diameter and distance values. The geometric data are displayed in sequence:
• d
distance value;
• di
diameter value.
When a geometric value is displayed, the corresponding LED illuminates on the display
panel.
- Check the values measured and then return the arm to the rest position. The machine
now presets for WIDTH measurement.
If an incorrect value has been acquired during the measurement phase, move the arm
to the rest position and then repeat the operation.
Operator's manual MT 3100 - MT3200
10
10a
73
Publicité
