Publicité
- position the end of the measuring arm on the plane chosen for the application of the
outer weight, as previously described for the inner side;
- read the distance d2 from the body on the rule;
- modify the value on the right display by pressing the
previously measured distance d2;
- press the
key again to set the machine for entering the nominal wheel diameter;
- read the rated rim diameter value on the tyre;
- modify the value displayed on the right display by pressing the
get the previously measured nominal diameter;
- press
to display the unbalance values (recalculated according to the new
dimensions) or
Applying balancing weights. (Fig. 15)
- Select the plane where the first balancing weight is to be applied.
- Turn the wheel until the central element of the corresponding position indicator lights up.
If the weight to be applied is of the conventional clip type (inner side in ALU 2P = EASY
ALU2), apply it at the corresponding 12 o'clock position. If the weight to be applied is
instead the adhesive type and the weight-holder device is installed, proceed as follows:
- position it inside the cavity of the weight-holder terminal of the measuring arm (Fig.
15,a,b), with the backing paper of the adhesive strip facing up. Then remove the
guard (Fig. 15c).
a
- IN THE MACHINE VERSION WITH AUTOMATIC SENSOR move the sensor until it reaches
the indicated position. In this phase, one display continues to show the unbalance
84
perform a wheel spin.
b
d
c
e
Operator's manual MT 3100 - MT3200
keys to get the
keys to
15
Publicité
