Publicité
- for the application of the balancing weights, refer to the following table:
Type of weight
Traditional clip
Adhesive
Adhesive
Adhesive
The positions on the wheel of H3, H6 and H12 are shown in Figure 11c.
Before starting a balancing operation, the following steps must be followed:
- fit the wheel on the hub using the most suitable flange;
- lock the wheel so that no movement is possible during the wheel spin and braking
phases;
- remove any counterweight, pebble, dirt or other foreign body;
- set the wheel's geometric data correctly.
Proceed as follows to balance a wheel in dynamic mode:
- press the
illuminates;
- press the key
Operator's manual MT 3100 - MT3200
BALANCING PROGRAMMES
d
YnaMic balancing
and keys until the LED corresponding to the DYN programme
to confirm the selection.
Weight application position
Always H12
H3
H6
H12
11c
(
)
standard
79
Publicité
