Publicité
3 inches less than the rated value must therefore be entered when the diameter is
set in order to obtain correct results;
- follow the instructions specified in the dynamic balancing procedure to perform a
test wheel spin.
Self-adhesive weights are generally used to balance alloy wheels and are applied dif-
ferently than for standard balancing (Fig. 12).
Several ALU balancing programmes are available, specially designed for these types
of rim.
ALU programmes can be selected as follows:
- press the
luminates;
- press the
desired (the corresponding balancing planes are highlighted on the rim shown on the
control panel).
alu 1p = easY alu1, alu 2p = easY alu2 p
These programs are used for maximum precision balancing of light alloy rims that re-
quire both weights to be applied on the same side (inner) in relation to the rim disk.
This type of wheel balancer is particularly suitable for application of adhesive weights
on the rim, thanks to the forward position of the wheel in relation to the body, which
allows a large zone on the inside of the rim to be accessed freely.
After selecting the desired ALU P = EASY ALU programme, the wheel data must be
acquired.
Operator's manual MT 3100 - MT3200
a
lloY wheel balancing
keys until the LED corresponding to the ALU programme il-
key as often as necessary to confirm selection of the Alu programme
(alu)
12
rograMMes
81
Publicité
