Publicité
- insert the two screws that are supplied in the holes on the wheel contact flange;
- tighten the screws on the adapter making sure that it rests on the flange correctly;
- fit the most suitable pin (depending on the wheel central hole) onto the shaft after
removing the threaded hub;
- mount the wheel after selecting the centring cones (one for each side of the wheel),
tighten with the appropriate ring nut using the spacers necessary for coupling the
securing cones to the threaded part of the shaft.
IMPORTANT: The wheel must be fixed to the flange so as to avoid any movement of
the two during the spin or braking phases.
- Press the
illuminates;
- press the
- mount the specific extension on the inner measuring arm, i.e. A if the weight-holder
device is not installed, B if the weight holder device is installed (Fig. 17 a).
Remember to remove this extension before performing the wheel spin;
- set the wheel data as usual;
- proceed as described for dynamic balancing.
Proceed as follows to balance motorcycle wheels dynamically using adhesive weights:
- press the
illuminates;
- press the
sponding balancing planes are highlighted on the rim shown on the control panel);
90
keys until the LED corresponding to the programme
key to confirm the selection;
M
otorcYcle
keys until the LED corresponding to the programme
key twice to select the "Motorcycle ALU" programme (the corre-
17
alu
prograMMe
Operator's manual MT 3100 - MT3200
17a
Publicité
