Connection Of The Positioner Type 8694 - Burkert TopControl Basic 8694 Manuel D'utilisation

Type 8694
Electricalinstallation24VDC
10.2.2 Connection of the positioner Type 8694
→
Connect the pins according to the model (options) of the positioner.
Input signals of the control center (e.g. PLC) - circular plug M12 x 1, 8-pole
Pin Wire color Configuration
15)
Set-point value + (0/4 – 20 mA)
1 white
2 brown
Set-point value GND
grey Binary input +
5
pink Binary input GND
6
Table 15: Pin assignment - input signals of the control center - circular plug M12 x 1, 8-pole
Output signals to the control center (e.g. PLC) - circular plug M 12 x 1, 8-pole
(required for analogue output option only)
Pin Wire color Configuration
15)
8 red Analogue position feedback +
7 blue Analogue position feedback GND
Table 16: Pin assignment - output signals of the control center - circular plug M12 x 1, 8-pole
Operating voltage (circular plug M12 x 1, 8-pole)
Pin Wire color Configuration
15)
4 yellow + 24 V
3 green GND
Table 17: Pin assignment - operating voltage (circular plug M12 x 1, 8-pole)
When the supply voltage is applied, the positioner is operating.
→
Make the required basic settings and actuate the automatic adjustment of the positioner, as described in the
chapter entitled "12 Start-up".
The indicated colors refer to the connecting cable available as an accessory (919061)
15)
External circuit / signal level
1 + (0/4 ... 20 mA)
2 GND
5 +
identical to Pin 3 (GND)
External circuit / signal level
8 + (0/4 ... 20 mA)
7 GND
External circuit
4
24 V DC ± 10 %
max. residual ripple 10 %
3
english
0 ... 5 V (log. 0)
10 ... 30 V (log. 1)
47