Installation; Installation Of The Valve; Installation Of The Minitop Type 8633 Onto The Valve Drive; General Notes - Burkert MiniTOP 8633 Instructions De Service

3

INSTALLATION

The dimensions of the MiniTOP and the various complete unit variants
consisting of MiniTOP, pneumatic drive and valve can be found in the
corresponding data sheets.
3.1

Installation of the valve

The dimensions and thread types can be found in the data sheet of the
process valve.
3.2 Installation of the MiniTOP Type 8633 onto
the valve drive

3.2.1 General Notes

The installation of the MiniTOP Type 8633 onto the valve drive and setting up
the switching points of the limit switches is carried out in a single sequence for
this unit, and is the same for the mechanical and the inductive variants.
An accessory set is necessary for connecting the MiniTOP to the valve drive.
This contains all the components that are necessary for the mechanical and
pneumatic connections. The accessory sets are available with hoses of the
necessary lengths, corresponding to the size of the valve drive.
The order numbers of the sets are listed in the technical data sheet.
Operating Instructions No. 803 925
29