MANUAL operating status (DIP switch 4 set to ON):
Key
Function
Aerate
1
(manually open / close the actuator)
Deaerate
2
(manually open / close the actuator)
Table 6:
Configuration of the keys for MANUAL operating status
AUTOMATIC operating status (DIP switch 4 set to OFF):
Key
Function
1
Press for 5 seconds to start the X.TUNE function
2
-
Table 7:
Configuration of the keys for AUTOMATIC operating status
Figure 15:
Position of the seal in the body casing
→
Version 1:
Check that the seal is correctly positioned in the body casing.
NOTE!
Breakage of the pneumatic connection pieces due to rotational impact.
▶ When unscrewing and screwing in the body casing or transparent cap, do not hold the actuator of the pro-
cess valve but the connection housing.
Damage or malfunction due to penetration of dirt and humidity.
▶ To observe degree of protection IP65 / IP67, screw the transparent cap in all the way.
→
Close the device (assembly tool: 674077
No function if the binary input was activated with the "Manual/Auto change-over" via the communications software
7)
Depending on the operating principle of the actuator.
8)
The assembly tool (674077) is available from your Bürkert sales office.
28
9)
7)
7)
).
9)
english
8)
8)
Body casing
Seal
body casing
Connection housing
Type 8694
Controlanddisplayelements