K Factor Of The 1St Flow Sensor; Selecting The Type Of Default Set-Value - Burkert 8623 Instructions De Service

7.3.3 K Factor of the 1st flow sensor

Setting the pre-comma value of the 1st K factor
Setting the post-comma value of the 1st K factor

7.3.4 Selecting the type of default Set-value

Select here whether the unit should work with an internal or an external
default set-value, or with ratio control.
The selection will be indicated in the upper row of bars.
Internal set-value
selected
(see 7.3.5)
Fig. 12: Selection of the default set value
Continue from 7.3.5, 7.3.6 or 7.3.7, depending on the selected
default set-value
Increase of the pre-comma value
Proceed to set the post-comma
value
Increase of the post-comma value
Continue from 8.3.4
External set-value
selected (standard
signal) (see 7.3.6)
Ratio control selected
(see 7.3.7)
8623 - 15