Features Of The Valve Types - Burkert TopControl Basic 8694 Manuel D'utilisation

The position of the actuator is regulated according to the position set-point value. The position set-point value is
specified by an external standard signal.
Pneumatically actuated piston actuators and rotary actuators can be used as an actuator. Single-acting actuators
are offered in combination with the positioner.
For single-acting actuators, only one chamber is aerated and deaerated in the actuator. The generated pressure works
against a spring. The piston moves until there is an equilibrium of forces between compressive force and spring force.
5.3 Features of the valve types
Angle seat control
valves / straight seat
control valves
Types • 2300
• 2301
• 2702
• 2712
Features • incoming flow under
seat
• no closing impact
• straight flow path of
the medium
• self-adjusting
stuffing box for high
leak-tightness
Typical
• water, steam and
media gases
• alcohols, oils, propel-
lants, hydraulic fluids
• salt solutions, lyes
(organic)
• solvents
Table 1:

Features of the valve types

12
Diaphragm valves
• 2103
• 2730
• 2731
• medium is hermeti-
cally separated from
the actuator and
environment
• cavity-free and self-
draining body design
• any flow direction with
low-turbulence flow
• steam-sterilizable
• CIP-compliant
• no closing impact
• actuator and dia-
phragm can be
removed when the
body is installed
• neutral gases and
liquids
• contaminated,
abrasive and
aggressive media
• media of higher
viscosity
english
Type 8694
Systemdescription
Ball valves Flap valves
• 2652 • 2672
• 2655 • 2675
• 2658
• scrapable • unaffected by
• minimum dead space
• little pressure
• unaffected by
contamination
• little pressure loss
• inexpensive
compared to other
valve types • low construction
• seat and seal can
be exchanged in the
three-piece ball valve
when installed
Note
can be used as
process controller only
• neutral gases and • neutral gases
liquids
• clean water • slightly
• slightly aggressive
media
contamination
loss compared to
other valve types
volume
and liquids
aggressive media