Selecting The Type Of Default Set-Value; Internal Default Set-Value (C.01) - Burkert 8625 Instructions De Service

7.3.4 Selecting the type of default Set-value

è Select here whether the unit should work with an internal or an external
default set-value. The selection will be indicated in the upper row of bars.
Internal default set-
value selected (see
7.3.5)
Proceed to 7.3.5 or 7.3.6
Fig. 10: Selection between internal and external set value

7.3.5 Internal default set-value (C.01)

For the internal default set-value, the set-value is output as a temperature in the
pre-selected units (°C or °F).
è Set the set-value within the limits of the selected temperature range.
Setting the pre-comma value of the internal set-value
Setting the post-comma value of the internal set-value
Operating Manual No. 800 209
External default set-
value selected (Stan-
dard signal) (see 7.3.6)
Increase of the pre-comma value
Proceed to set the post-comma
value
Increase of the post-comma value
Continue from 7.3.7
37