Burkert TopControl Basic 8694 Manuel D'utilisation page 41

Type 8694
Installation
Key contour
Nipple
Figure 29: Rotating the actuator module
→
Using a suitable open-end wrench, counter the wrench flat on the pipe.
→
Actuator module without hexagon:
Fit special key exactly in the key contour on the underside of the actuator.
14)
→
Actuator module with hexagon:
Place suitable open-end wrench on the hexagon of the actuator.
WARNING!
Risk of injury from discharge of medium and pressure.
If the direction of rotation is wrong, the body interface may become detached.
▶ Rotate the actuator module in the specified direction only (see "Figure 30") .
→
Actuator module without hexagon:
Rotate clockwise (as seen from below) to bring the actuator module into the required position.
→
Actuator module with hexagon:
Rotate counter-clockwise (as seen from below) to bring the actuator module into the required position.
Figure 30: Rotating with special key / open-end wrench
The special key (665702) is available from your Bürkert sales office.
14)
Actuator
module
without hexagon
Open-end wrench
Special key
with hexagon
Hexagon
Nipple
with hexagon
without hexagon
english
41