Publicité
Mise en route / Start-up / Inbetriebsetzung
C
T
RACTOR CONTROL
To be checked:
• The total authorised weight.
• The permitted weight per axle.
• The authorised support weight on the tractor's linkage.
• The permissible load capacity for the tyres fi tted to the tractor.
• Is the authorised linkage weight suffi cient?
All of this information can be found on the registration papers, or on the data plate and in the tractor manual.
F
IGURES THAT YOU SHOULD KNOW
P
Kg
P1
Kg
P2
Kg
M2
Kg
Total weight with machine attached to rear
M1
Kg
Distance between the centre of gravity of the
m
A
front ballast and the centre of the front axle
m
B
Distance between the lower linkage pins
m
C
and the centre of the rear axle.
Distance between the lower linkage pins
m
D
and the centre of gravity of the machine.
M1 mini = Calculation of the minimum ballast need in front.
P1c = Calculation of the weight on the front axle
Pc = Calculation of the total weight of the unit (tractor + machine)
P2c = Calculation of the weight on the rear axle
V
ALUES CALCULATED
P1
C
P2
C
P
C
- Complete the table below:
- Check that:
• The values calculated should be < or = to the tractor's permissible values and the values for the tyres fi tted to the tractor.
• It is essential that the minimum load on the front axle is > or = to 20% of the unladen tractor weight.
The machine must not be hitched to a tractor if:
The total weight calculated is > than the maximum authorised weight.
The weight on the front axle is < than the minimum required.
Unladen weight of tractor
Weight on the front axle
when the tractor is empty
Weight on the rear axle
when the tractor is empty
Total weight of front ballast
Wheelbase of tractor
T
Consult the tractor's instruction manual
or the registration documents.
Consult the technical characteristics of the machine.
(see section
Consult the technical characteristics
of the tractor and the front ballast, or measure.
Consult the instruction manual
or the tractor's registration documents, or measure.
Consult the technical characteristics of the machine.
(see section
'
RACTOR
S PERMISSIBLE VALUES
5
«Characteristics»).
5
«Characteristics»).
V
ALUES PERMISSIBLE WITH THE TYRES THAT ARE
FITTED TO THE TRACTOR
1
EN
19
Publicité
