Using The Automatic Wheel Clamping System C - Corghi EM 9380 XLine Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

USING THE AUTOMATIC WHEEL
Procedure for locking the wheels with the automatic C system:
Centring with front cone
- Fit the wheel on the shaft, sliding it into place until it rests against the flange.
- Fit the most suitable cone on the shaft and insert it into the central hole of the wheel.
- Fit the locking device by making it slide on the hub until it comes into contact with the
cone.
- Press the control pedal for at least one second.
Centring with rear cone
- Fit the most suitable cone for the central hole of the wheel on the shaft.
- Fit the wheel onto the cone, sliding it into place until the cone comes into contact with
the plate that holds the spring.
- Apply the protective cap to the sleeve.
- Fit the locking device by making it slide on the hub until it comes into contact with the
wheel.
- Press the control pedal for at least one second.
Wheel release
- Press the control pedal for at least one second to release the wheel from the flange.
Centring with flanges
Removing the C hub
- Insert the special C key (supplied with the
machine) in the slot of the C hub (fig.11);
- Completely unscrew the C hub;
- Mount the flange on the shaft and lock it in
place with the two screws (A, fig.12) using
the CH 6 wrench.
- Lock the wheel onto the flange as usual.
Assembling the C hub
To reassemble the C hub, proceed as follows:
- Hold down the keyboard key
for at least 3 seconds to lock the shaft ro-
tates and bring to the open position, the
pneumatic cylinder of the clamping device
C; The message A 52 will be displayed on
the monitor.
- insert the split pin (supplied with the
machine) in the cylindrical protection bush
(B, fig.13)
- Pull the split pin as per picture 13 then
96
CLAMPING SYSTEM C
Operator's Manual EM 9380 XLine - EM 9380C XLine
A
11
12

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Em 9380 c xline

Table des Matières