Hologic Aquilex Fluid Control System Manuel D'instructions Et D'utilisation page 31

Masquer les pouces Voir aussi pour Aquilex Fluid Control System:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 103
1. Turn system off.
2. Disconnect system from wall power outlet.
3. The fuse holder is located on the back of the pump, next to the male connec-
tion.
4. Remove both fuse holders as depicted in Figure 7-1, using small flathead
screwdriver.
5. Pull out the fuse holders.
6. Check the fuses.
7. Insert new fuses. Use only the specified type of fuse (see Chapter 10, Techni-
cal Data).
8. Insert the fuse holders.
9. Reconnect the power cord and connect the pump to the wall outlet.
Care and Maintenance
Figure 7-1 Opening the fuse holder
EN
27

Publicité

Table des Matières
loading

Table des Matières