Chapter 7: Disassembly And Disposal - Hologic FLUENT Manuel D'utilisation

After completing the procedure with the Fluent Fluid Management System, you are ready to disassemble and dispose of materials that you used
during the procedure. This chapter provides information and instructions for disconnecting the Fluent Procedure Kits and other components from
the Fluent Fluid Management System, and information for disposing of components.
WARNING! Reprocessing of sterile disposable products
Reuse of Fluent In-FloPaks or Fluent Out-FloPaks can cause an infection hazard for patients and/or users as well as impair product functionality.
Contamination and/or impaired functionality of the system can cause risk of injury, illness, or death. Do not re-process single-use Fluent In-
FloPaks or Fluent Out-FloPaks.
Note:
Comply with your facility's hygiene rules when disposing of Fluent Procedure Kits, the Tissue Trap, fluid collected, and the Waste Bag.
Disassembly and Disposal
1. Remove the MyoSure Tissue Removal Device (TRD) and hysteroscope from the patient.
2.
Perform the following steps:
1.
Disassemble the MyoSure Tissue Removal Device (TRD)
a. Remove the TRD from the hysteroscope.
b. Disconnect the outflow TRD Tube from the TRD.
c.
Disconnect the TRD from the Fluent Fluid Management System console.
d. Dispose of the TRD according to your facility's protocol.
2. Collect Pathology
a.
Locate a pathology container (not supplied).
b. Pull the waste bag connector from the Waste Bag to detach.
c. Open the Tissue Trap Holder lid.
d.
Remove the Tissue Trap and place it into the pathology container.
e. If additional tissue is to be collected, place a new Tissue Trap into the Tissue Trap Holder. Close the Tissue Trap Holder lid securely
and attach the Waste Tube Connector to the Waste Bag.
3.
Dispose of Waste Materials
a. Screw on the attached Waste Bag Cap and remove the Waste Bag.
b.
Discard the Waste Bag according to your facility's protocol.
4.
Disassemble the Under Buttocks (UB) Drape
a. Remove the Under Buttocks (UB) Drape Tube from the Under Buttocks (UB) Drape Port.
b.
Dispose of the Under Buttocks (UB) Drape according to your facility's protocol.
5.
Disassemble the Hysteroscope
a. Clamp the hysteroscope Inflow Tube.
b.
Remove the hysteroscope Inflow Tube.
c.
Remove the hysteroscope Outflow Tube.
6. Disassemble the Fluent In-FloPak
a. Clamp the Fluid Bag Tube.
b.
Remove the spike from the Fluid Bag.
c. Remove the Fluent In-FloPak from the Fluent In-FloPak Receptacle on the front left side of the Fluent Fluid Management
System console.
d. Dispose of the Fluent Out-FloPak according to your facility's protocol.
30
Fluent Fluid Management System

Chapter 7: Disassembly and Disposal

Chapter 7: Disassembly and Disposal English