Publicité
5.1.1 STORAGE
The packaged product can normally be stored in a closed environment as long as the temperature is not lower than
-0 °C or higher than +50 °C (32-122 F) and the humidity does not exceed 80%.
No other packages must be placed on top of the packaging.
Special care must be taken for fragile materials.
Follow the position indications marked on the packaging.
Special care must be taken during loading, unloading, transport, so as to avoid shocks and damage.
Make sure that the packaging has not been damaged during these operations.
No damaged packaging shall be repaired by the customer.
CAUTION
It should be remembered that certain effects resulting from the exposure of a product to environmental conditions
are the direct consequence of its exposure in sequence to two or more factors or parameters, among which are
particularly critical:
➢ thermal shock, which may result from exposing the product to high temperature conditions immediately
after exposure to low temperature conditions or vice versa, or subjecting the product to water (rain, water
jets, snow, immersion, etc. all forbidden conditions) immediately after exposure to high temperature
conditions;
➢ the formation of ice, which may result from exposing the product to below-freezing temperatures
immediately before or after exposure to moisture, rain or water due to causes other than rain.
CAUTION
After storing the product within the limits of the above-mentioned conditions, it is required that it be kept in non-
operative condition for approximately 12 hours in order to re-establish the correct ambient temperature conditions
permitted (see paragraph 4.7) so as to avoid damage to the electrical/electronic part as a result of thermal shock,
ice formation or humidity, etc., which may deteriorate or damage these circuits.
NOTE: any conditions other than the above may be indicated in the specific documentation of the components,
where present and supplied. In this case, the instructions in the specific documentation must be followed.
5.2
PRODUCT ASSEMBLY
The following section describes how to assemble the product according to the composition purchased and
permitted.
5.2.1
SHEAR WITH BATTERY ASSEMBLY
The product covered by this manual is supplied already assembled and ready for use, except for the battery, which
must be inserted into the product as shown below and/or allowed accessories.
1)
Open the package containing the product.
2)
Take the product out of the holster. All Campagnola s.r.l. shears, as per factory settings, are supplied with
closed blades.
3)
Hold the shears in a horizontal position, as shown;
4)
Make sure you only use batteries that are compatible with the product (see par. 2.2);
5)
Ensure that the battery-side and shear-side contact terminals are undamaged and clean;
6)
Proceed by inserting the battery (7) into the guides (15) on the rear of the shears until it is mechanically locked,
signalled by the click of the safety catch (11).
0310.0429_00
99
Publicité
