Publicité
3.
PRODUCT DESCRIPTION
The product covered by this manual is a battery-powered, electric pruning shear, as shown in the table of possible
combinations above, the permitted use of which is specified in the following paragraph.
The shears are equipped with hardened steel blades.
The cutting force is provided by a brushless electric motor, which transmits motion to the blades via a series of
gears.
The movement of the blades is detected by a sensor board, and actuating the operating lever activates cutting.
The various cutting functions are programmed into the drive board and are activated by specific actions on the drive
lever and on the On-Off button.
Some functions are managed by an App, which can also be consulted for information on the status of Shear use.
3.1 PERMITTED - INTENDED USE
The product is for a professional use only in agriculture.
The Electric Shear is a product dedicated exclusively to pruning orchards, vineyards, citrus orchards, olive groves
and all plants in general. It is capable of cutting woody plants with a maximum diameter as shown in the technical
data table in paragraph 2.2.
The use of these products must only and exclusively be entrusted to trained and authorised personnel with the
professional knowledge and skills to ensure their safe and proper use.
The training and sensitizing of the operator must be entrusted to skilled personnel, capable of developing qualified
theoretical and practical training to enable them to correctly implement all the technical operations and behaviours
that are decisive for their own safety and the safety of persons working in the areas where the product is used.
Ways of use specified in the manual as incorrect must never be permitted under any circumstances.
Improper use of the product and/or lack of maintenance can lead to serious danger to personnel.
The actions described in this manual as forbidden and not permitted, which obviously cannot cover the whole
range of potential possibilities for "non-permitted use" of the product, are however the most "reasonably"
foreseeable ones and are to be considered absolutely forbidden.
Only use the product from the ground in a safe and stable position, ensuring perfect and stable balance during use
and handling.
It is forbidden to use the product when precariously balanced on surfaces where the risk of slipping is present (for
example on a hill and/or on damp grass, snow, ice, etc.) or any place where it is impossible to maintain a stable
balance (for example on steep slopes).
Avoid working in bad weather conditions, such as fog, heavy rain, strong winds, hailstorms, snow and ice,
thunderstorms (risk of electrocution).
Cutting activities must be carried out in compliance with the maximum cutting dimensions specified in the technical
data table of the purchased product and only with woody plants.
It is forbidden to cut branches that are larger than the maximum diameter allowed and stated on the technical data
table.
To ensure an ergonomic working condition, avoid cutting above shoulder height.
Do not carry out cuts above shoulder height; in order to avoid incorrect ergonomic operating conditions, which
could cause postural hazards for the operator over time.
CAUTION
•
Any other use has to be considered improper and potentially dangerous for the operators' safety. This
would make any of the Manufacturer's liability and warranty claims void.
•
If the tool is used for purposes other than those listed, it may be seriously damaged and cause damage to
property and persons.
Any other use, or the extension of the use beyond that intended, is prohibited and does not correspond
to the intended purpose of the manufacturer, and therefore the manufacturer cannot accept any liability
for any resulting damage.
0310.0429_00
76
Publicité
