Publicité
7.3.3 RECOMMENDED LUBRICANTS AND ADHESIVES
The product has been designed in such a way as to reduce lubrication-related operations; however, due to its
inherent use, lubricants for the cutting part are required.
See chap. 7.1.3 Blade lubrication
Characteristics of the greases and lubricating oils used
The data sheets for greases and lubricating oils in this section only contain the main technical characteristics
required for purchase, but not the safety information related to their use.
Before use, request the 'product safety data sheet' from the manufacturer, which can also normally be found on the
supplier's website.
NOTE. The chemical-physical properties of the greases and lubricating oils in this section are extracted from
suppliers' catalogues and are therefore subject to changes beyond our control.
Do not use any grease other than that indicated by the manufacturer where it is to be used.
Do not mix with other lubricants.
When handling/using grease, always use waterproof protective gloves and observe the safety data sheet of the grease.
Careful use is recommended.
Be reminded that:
● inhalation of vapours generated by burning product at a temperature above 300 °C can lead to operator
malfunctions;
● smoking is prohibited;
● it is mandatory to wash hands after handling the product.
Supplier
Type
Use
Colour
Appearance
Solid additives
NLGI consistency
Drop point
Temperature range of use
The colouration assumed by the grease after a certain period of operation varies according to the presence of
contaminating Fe2O3 particles and indicates the residual lubricating capacity of the grease.
NOTE: The grease specified above must be used for all maintenance activities relating to the greasing of gears, blades,
mechanical parts; in all disassembly/assembly and/or adjustment activities covered by the maintenance activity.
While the product is in use, the LUBE SPRAY GREASE indicated below must be used to lubricate the blades,
which is prescribed by the product manufacturer Campagnola s.r.l.and can be purchased separately.
Supplier
Type
Use
Physical state
Colour
Flash point
Water solubility
Solubility in oil
0310.0429_00
Grease commercial data
Pakelo Motor Oil Srl
Multiplex EP Grease TEF NLGI 2
Suitable when exceptional load and wear resistance is
required in a variety of applications.
Grease technical properties
Brown
Creamy
P.T.F.E.
2
>280°
-30° /+140° (<180°)
Commercial data of lube spray grease
Pakelo Motor Oil Srl
Campagnola lube spray grease
Lubricant
Lube spray grease technical properties
Liquid Gas
Yellow
˂0° C
Insoluble
Soluble
117
Publicité
