Publicité
8. TROUBLESHOOTING
Troubleshooting can only be carried out by trained personnel who have understood the instructions in this manual
and the accompanying documentation.
Situations that can lead to a failure are normally attributable to a lack of or poor maintenance or a failure of some
mechanical and/or electrical/electronic component of the product or a situation related to the material being handled.
The following table lists possible faults that can occur on the tool. The "Cause" column shows the cause of the fault
condition.
The "Solution" column shows the corrective action to resolve the fault situation that has occurred.
FAULT
The product is not working.
The blade locks.
High shear temperature
Locked motor
The shear is not powerful
enough
0310.0429_00
CAUSE
Incompatible battery
Low battery
Damaged or dirty connector
Insufficient lubrication
Non-compliance with cutting
conditions
Non-compliance with cutting
conditions
Damaged electronics
Overcurrent caused by excessive
strain
Locked mechanics
Low battery
Battery at end of life or to be
replaced
119
SOLUTION
Replace the battery with a compatible one
Recharge the battery
Contact a T.A.C.
Lubricate the blades
See working standards in chapter 6.3
See chap. 6.3 working and sectioning
rules. Wait for the temperature to drop
below 20°
Contact a T.A.C.
Contact a T.A.C.
Contact a T.A.C.
Recharge the battery
Contact a T.A.C.
Publicité
