Publicité
4.17 WARNING PLATES
Depending on the residual risks of various kinds identified for the product, CAMPAGNOLA S.r.l. has equipped it with
danger, warning and obligation plates, defined in accordance with the European regulations concerning the graphic
symbols to be used (Directive 92/58/EEC).
The plates in question are located in a highly visible position.
CAUTION
It is absolutely forbidden to remove the warning plates on the product. CAMPAGNOLA srl. will not be held liable
for the safety of the product if this prohibition is disregarded.
CAUTION
Following use of the product in the workplace, it will be the responsibility of the customer/end user to adopt the
necessary signage, depending on the residual risks present.
CAUTION
The customer/user is obliged to replace warning plates that are illegible due to wear and tear.
4.17.1 PLACEMENT OF WARNING PLATES
On all models manufactured by CAMPAGNOLA S.r.l., warning plates have been identified in order to signal
the residual risks present, the specific types of which are shown below.
Due to the size of the product, it is not possible to install warning plates, which have been identified for the
product, and for this reason the manufacturer has affixed the CE marking plate with the pictogram of the
obligation to read and understand the manual in its entirety.
Please note that it is the user's precise responsibility, on receipt of the product, to ensure the integrity of the
CE plate affixed to the product in the position indicated and of the warning plates shown below for the purpose
of the correct management of the product and the residual risks that remain despite the technical solutions
adopted.
Information pursuant to "WEEE"
Directive 2012/19/EU: See
paragraph 4.11
0310.0429_00
Position of the CE plate affixed to the
product/tool
97
Obligation to read and understand
the manual provided in its entirety
Publicité
