Publicité
Indicator lights on means that the tool is ready for operation.
Flashing lights indicate that the tool is blocked due to a malfunction.
In this condition, to start the tool back up again refer to the alarm list.
DANGER
During operation and maintenance of the product, use footwear, gloves and goggles or safety screen.
DANGER
•
Do not transport the product with the blades open.
•
Always carry the product in a holster.
•
Before connecting the battery, make sure that the connector has clean contacts (no dirt or other obstructive
material), that they are dry and free of oxidation.
•
Disconnect the battery pack before carrying out any adjustments or routine and extraordinary maintenance.
•
For sharpening and maintenance of the blades, follow the instructions in this manual.
•
Only use the product with the accessories specified by the Manufacturer.
•
Before any routine maintenance operations, read this manual carefully. For maintenance activities that are
not indicated in the manual, please contact the manufacturer's T.A.C. (Technical Assistance Centre).
•
Maintain all labels and pictograms on the tool in a perfectly legible and undamaged condition, with particular
reference to those relating to danger and safety signs.
BEWARE OF KICKBACK
Kickback can occur under various conditions, such as cutting a 'material' under tension. In order to
prevent kickback, make sure beforehand that the material is not under tension, that it is of the required
type (woody material) and that it is under control by gripping it firmly. By knowing the correct
conditions of use and prevention, the surprise factor and the occurrence of accidents can be
eliminated. Ensure that the area where you are cutting is free of obstacles and/or materials that can be
ejected.
CAUTION
Before carrying out any maintenance or mechanical adjustment of the product, it is imperative to wear
PPE such as safety shoes, overalls, puncture-proof gloves and goggles to protect the face.
•
Any repair or maintenance work may only be carried out by duly trained personnel. Informed and instructed,
and authorised with the required professional profile (mechanical maintenance technician and/or electrical
maintenance technician) depending on the type of work to be carried out.
•
Only the adjustment, lubrication of the blades and cleaning of the product can also be carried out by the
operator. While all other maintenance activities are precluded to them.
•
It is a mandatory requirement to disconnect the product from the power source before any adjustment
and/or maintenance work (battery pack).
•
During operation, maintenance and/or repair work, unauthorised persons must keep a distance of at least
5 metres from the operating range of the product.
•
The removal of protective or safety devices (where fitted) must only be carried out for extraordinary
maintenance operations and only by maintenance personnel, after disconnection of power sources. The
maintenance technician must ensure the safety of all personnel, also in order to avoid any damage to the
product, as well as to restore the effectiveness of the equipment itself at the end of maintenance and
always before using again.
•
All the maintenance operations which are not described in this manual have to be performed by the
manufacturer's T.A.C.
•
The maintenance, repair and troubleshooting work must be concluded with the verification of the correct
functioning and of all active safety devices.
•
When maintenance or repairs have been completed, the product can be started again only if duly verified
by a maintenance technician, who must make sure that:
-
work has been completed;
-
the product works perfectly;
-
the safety devices are activated;
-
no one is operating on the product.
0310.0429_00
94
Publicité
