Publicité
6.2.4 STOPPING THE PRODUCT
•
Before storing the product in the holster after use, make sure the blade (3) is closed to avoid dangerous
conditions.
•
Pressing and holding the operating lever (1) will close the blade (3).
•
Next, press the ON/OFF switch (5) for at least one second to switch off the shears.
•
Close the blade (3) and switch off the product, before: placing it on a surface, placing it in the holster and
putting it away.
•
Disconnect the battery/battery pack (7).
CAUTION
Do not place or leave the product unattended with the cutting blade (3) open, in order to avoid danger
or damage to property or persons.
6.2.5
PRODUCT STOP MOUNTED ON TELESCOPIC EXTENSION POLE
• Pressing and holding the operating lever (26) will close the blade (3).
• Next, press the ON/OFF switch (5) for at least one second to switch off the shears.
• Close the blade (3) and switch off the product, before: placing it on a surface, placing it in the holster and
putting it away.
• Remove the battery (7) by unlocking the safety catch (11) and store it according to the instructions in
section 3.7 battery use.
6.3 WORKING AND SECTIONING INSTRUCTIONS
Regardless of the selected work mode (Automatic or Progressive) and the blade opening function (full or partial),
this section describes the correct way to perform the sectioning cut.
6.3.1
SECTIONING CUT WITH HAND-OPERATED SHEAR
With the shears switched on and ready to operate, insert the blades (2-3) into the branch.
Then start the cutting cycle by pressing the operating lever (1) in order to make the branch sectioning cut.
If the branch is oversized (larger than the permitted size) or too hard, the cut may not be successful.
Under these conditions, the sensors in the shear do not detect the end of the cutting cycle and therefore the blades
automatically reopen.
Before proceeding with a further cutting cycle, ensure that the branch is of the appropriate size (see paragraph 2.2)
for the type of shears being used. In the case of branches that are too hard, refer to paragraph 6.3.2.
6.3.2
SECTIONING CUT WITH SHEAR MOUNTED ON EXTENSION POLE
With the shears switched on and ready to operate, insert the blades (2-3) into the branch.
Then start the cutting cycle by pressing the operating lever (26) in order to make the branch sectioning cut.
If the branch is oversized (larger than the permitted size) or too hard, the cut may not be successful.
Under these conditions, the sensors in the shear do not detect the end of the cutting cycle and therefore the blades
automatically reopen.
Before proceeding with a further cutting cycle, ensure that the branch is of the appropriate size (see paragraph 2.2)
for the type of shears being used. In the case of branches that are too hard, refer to paragraph 6.3.2.
0310.0429_00
107
Publicité
