Pit Boss PRO Serie Manuel De L'utilisateur page 13

15. INSTALLING THE POWER CORD
NOTE: There are two Power Cords supplied. Select the Power Cord that is
required for your region.
Parts Required:
1 x Power Cord Clip (#29)
1 x Power Cord (#30 or #31)
Installation:
• Place the Power Cord Clip on the Power Cord. Then, insert the Power
Cord into the groove at the bottom of the unit. Note 15A.
• Secure the Power Clip to the bottom panel using the pre-installed
screw, as shown. Note 15B.
16. CONNECTING TO A POWER SOURCE
• STANDARD OUTLET
This appliance requires 220-240 Volt, 50 Hz, 275 W. It must be a
grounded plug. Ensure grounded end is not broken off before use. The
control uses a 220-240 volt, fast-blow fuse to protect the board from
the ignitor.
IMPORTANT: Disconnect unit from power source when not in use.
15
15A
30/31
15B
29
16
13