Corghi Artiglio 500 Manuel D'utilisation page 55

5.9.c. SPECIAL PROCEDURE
If, during inflation, the tyre does not
seat on the rim because of the excessive
gap between the tyre/rim, it is possible
to use an air-pressure airblast through
the jaws on the TI accessory (available
on request).
Verify that both upper and lower tyre
beads and the rim bead seat have been
properly lubricated with an approved
mounting paste.
1. Locking the rim (Fig. 44a).
2. Remove the valve stem core if not
already done (Fig. 44b).
3. Connect the inflation hose to the
valve stem (Fig. 44c).
4. Pull up on the tyre lightly to reduce
the gap between the upper bead and
the rim (Fig. 44d).
5. Step down completely on the air
inflation pedal and at the same time
press the 2 buttons on the accessory
to release a high-pressure air blast
through the four jets to assist in seating
the beads of the tyre (Fig. 44e).
Artiglio 500 User Manual
44d
44a
44b
44c
UK
44e
55