Corghi Artiglio 500 Manuel D'utilisation page 17

• rotation torque............................................................................................................ 1100 Nm
• rotation speed .......................................................................................................... 7 - 18 rpm
- Bead Breaker Unit:
• bead breaking cylinder force ......................................................................................... 7600 N
- Wheel lift:
• lifting capacity ................................................................................................................... 85 Kg
- Power supply:
• electric 1 Phase ............................................................................... 230V-0.75 kW 50Hz/60 Hz
• electrical 1 Phase (alternative) ..................................................... 110V-0.75 kW 50Hz/60 Hz
• pneumatic operating pressure ..................................................................................8÷10 bar
- Weight .......................................................................................................380 kg (with wheel lift)
- Noise level
• Weighted noise level A (LpA) in working position ..............................................< 70 dB (A
The stated noise levels are emission levels and do not necessarily represent safe operating
levels. Although there is a relationship between emission levels and exposure levels, this
cannot be used reliably to establish whether or not further precautions are necessary. The
factors which determine the level of exposure to which the operator is subjected include the
duration of the exposure, the characteristics of the workplace, other sources of noise, etc. The
permitted exposure levels may also vary from country to country. However, this information
will enable the machine's user to make a more accurate evaluation of the hazard and risk.
1.2.e. AIR PRESSURES
The machine is equipped with an internal pressure limiting valve to minimize the risk of
over inflating the tyre.
1. Never exceed these pressure limitations:
• Supply line pressure (from compressor) is 220 psi (15 bar).
• Operating pressure (gauge on regulator) is 145 psi (10 bar).
Bead setting pressure (gauge on hose) is the tyre manufacturer's maximum pressure as
stated on the sidewall of the tyre
2. Activate air inflation jets only when sealing the bead.
3. Bleed air pressure system before disconnecting supply line or other pneumatic compo-
nents. Air is stored in a reservoir for operation of inflation jets.
4. Only activate the air inflation jets if the rim securing device is locked in place and the tyre
is properly clamped (when possible).
Artiglio 500 User Manual
DANGER
• EXPLOSION HAZARD
• Never exceed the tyre pressure recommended by the tyre
manufacturer. Never mismatch tyre size and rim size.
• Avoid personal injury or death
UK
17