Corghi Artiglio 500 Manuel D'utilisation page 16

pressure range from no less than 8.5 bar to no more than 16 bar and guarantee an air flow
rate greater than the average consumption of the machine, which is equal to 120 Nl/min.
For correct equipment operation, the air produced must be suitably treated (not
above 5/4/4 according to ISO 8573-1)
Check that the Lubricator unit B fig. 2a contains air
lubricating oil; top up if necessary. Use SAE20 oil.
The customer must provide an air cut-off valve upstre-
am of the air treatment and regulator device supplied
with the machine.
Before operating any command, follow the
instructions affixed to the machine.
See also Section 3.3, "FIRST INSTALLATION"
1.2.d TECHNICAL DATA
- Tyre types processed ................................. conventional runflat with reinforced sidewall
- Wheel dimension range:
• rim diameter ................................................................................................ from 12" to 32"
• maximum tyre diameter .............................................................................. 1200 mm (47")
• maximum tyre width .................................................... 15" (from wheel support surface)
- Turntable:
• rest ..............................................................................................................................flanged
• centring ..................................................................................................................... on cone
• clamping ....................................................................................................mechanical-manual
• drive system............................................................................... 2-speed motor-inverter unit
16
NOTICE
WARNING
and/or with internal support
Artiglio 500 User Manual
B
2a