Corghi Artiglio 500 Manuel D'utilisation page 23

This lifting point must be used whenever you need to change the installation position of
the machine. Do not attempt to move the machine until it has been disconnected from
the electricity and compressed air supply systems.
3.2. INSTALLATION CLEARANCES
The machine must be installed in accordance with all applicable safety regula-
tions, including but not limited to those issued by OSHA.
RISK OF EXPLOSION OR FIRE. Never use the machine in an area where it will
be exposed to flammable vapours (gasoline, paint thinners solvents, etc.). Never
install the machine in a recessed area or below floor level.
IMPORTANT: for the correct and safe operation of the machine, the lighting level in
the place of use should be at least 300 lux.
Do not install the machine outdoors. It is designed for use in an indoor, sheltered area.
Install the tyre changer in the cho-
sen work position, complying with
the minimum clearances shown
in Fig.8.
The surface must have a load-carry-
ing capacity of at least 1000 kg/m
Artiglio 500 User Manual
WARNING
DANGER
NOTICE
.
2
1200 mm
UK
8
23