Corghi Artiglio 500 Manuel D'utilisation page 24

- Relative humidity 30% - 95% without condensation.
- Temperature 0°C - 50°C.
3.3. FIRST INSTALLATION
Normally, the machine is supplied in the configuration as shown in fig.8a: tool holder
arm closed and arm opening control valve to the right (see fig. 8b), bead breaker
arms fully forward.
These configurations may move during transport
and the air can be released from the actuating
pneumatic cylinders.
Before making the connection to the pneumatic
network, check the configuration of the arms and
controls as described in fig. 8a-8b.
After making the connection, in order not to dam-
age the gaskets and cause violent movements, fol-
low the sequence described below before moving
8b
24
Work environment conditions
WARNING
the bead breaker arms:
hold down the arm re-
lease button (A, fig. 8c)
and move the lever to
the left (B, fig. 8c).
B
A
Artiglio 500 User Manual
8a
8c