Publicité
Les langues disponibles
Les langues disponibles
43c
43d
43b
3. Remove the valve stem core if not already done
(Fig. 43c).
4. Connect the air hose Doyfe inflator chuck to the valve stem (Fig. 43d).
5. Press
to inflate the tyre. The tyre will expand, and the
beads will seat.
1
If necessary:
6. Continue inflating up to the maximum value of 3.5 bar to
position the tyre correctly on the rim. Avoid distractions dur-
2
ing this operation, and continually check tyre pressure on the
air pressure gauge (1, Fig. 43e) to prevent excessive inflation.
Inflating tubeless tyres requires a higher air flow-rate to allow
43e
the beads to bypass the rim HUMPS - see types of rim profiles
for mounting without a camera in Fig. 43f.
7. From the position of the centring ridges check
"HUMP" (H)
that the beads are properly positioned on the
rim; otherwise, deflate the tyre, break the beads
as described in the relevant section, lubricate
and turn the tyre on the rim. Repeat the mounting
operation described previously and check again.
8. Replace the internal mechanism of the valve.
9. Bring the pressure to the operating value by
pressing the Inflation push-button (2, Fig. 43e).
"double HUMP" (H2)
43f
10. Fit the cap to the valve.
Artiglio 500 User Manual
54
Publicité
