Corghi Artiglio 500 Manuel D'utilisation page 22

- Remove the packaging from the air tank and/or any optional units, and place them in a
position where they cannot fall over and be damaged.
- Remove the wood strip that supports the top bead breaker.
Support the arm before removing the strip. The arm could drop violently.
- Reassemble the tool drive cylinder D.20x400
as shown in figure 6a; the cylinder is shipped
strapped to the arm.
- Fit the wheel lift (fig. 6b) using the three screws.
- Connect the tank union to the air connec-
tion pipeline provided, securing it with
a band clamp. Secure the air tank to the
machine using the bracket provided, with
screws (A) and nuts (B) (fig.5) (T.I. version
only).
To remove the machine from the pallet
connect to it by means of the lifting bracket
1 provided, as shown in fig. 7.
22
WARNING
6b
Artiglio 500 User Manual
6a
7