Publicité
Les langues disponibles
Les langues disponibles
AVOID PERSONAL INJURY
It is forbidden pairs or uses centring and clamping accessories other than those speci-
fied in the "tables for using centring and clamping accessories according to rim type"
When working with "easily deformable" rims (i.e. a
central hole with thin, projecting edges - see Fig.
21) we recommend using the universal turntable for
blind rims (see the section "TABLE FOR USING CEN-
TRING AND CLAMPING ACCESSORIES ACCORDING
TO RIM TYPE" on this manual).
Deciding from which side of the wheel the tyre must
be demounted
See Fig. 22. Find the position of rim well A on the
wheel rim. Find the largest width B and the smallest
width C. The tyre must be mounted and demounted
with the wheel on the turntable with the smallest width
side C facing upwards.
Special wheels
Alloy rim wheels: some alloy rim wheels have minimal
rim wells A or no rim wells at all - Fig. 23a. These rims
are not approved by DOT (Department of Transpor-
tation) standards. The initials DOT certify that tyres
comply with the safety standards adopted by the
United States and Canada (these wheels cannot be
sold on these markets).
High-performance wheels (asymmetric curvature) -
Fig. 23b: Some European wheels have rims with a very
pronounced curvature C, except in the area of the valve
hole A where the curvature is less pronounced B. On
these wheels the bead must first be broken in the area
of the valve hole, on both the top and bottom sides.
Wheels with pressure sensor - Fig.23c. To operate cor-
rectly on these wheels and avoid damaging the sensor
(which is incorporated in the valve, fixed with the
belt, glued inside the tyre, etc.) appropriate mount-
ing/demounting procedures should be followed (ref.
Approved mounting/demounting procedure for runflat
and UHP tyres)
Artiglio 500 User Manual
WARNING
A
B
21
22
23a
A
23b
A
23c
C
A
B
UK
C
B
C
35
Publicité
