AC MAGNETO AND STARTER CLUTCH
1
7. Install:
• Shaft 1
• Bearing 2
• Idle gear 2 3
NOTE:
Apply the engine oil on the shaft, bearing and
idle gear inner circumference.
8. Install:
• Dowel pin
• Gasket [crankcase cover (left)]
• Crankcase cover (left) 1
• Bolt [crankcase cover (left)]
NOTE:
Tighten the bolts in stage, using a crisscross
pattern.
9. Install:
• Plain washer
• Torque limiter 1
• Plain washer
NOTE:
Apply the engine oil to the shaft and plain
washers.
10. Install:
• Cover (idle gear 1) 1
• Bolt 2
NOTE:
Install the cover (idle gear 1) with its mark a
facing upward.
11. Connect:
• AC magneto lead
Refer to "CABLE ROUTING DIAGRAM"
section in the CHAPTER 2.
12. Install:
• Shift pedal 1
• Bolt (shift pedal)
NOTE:
When installing the shift pedal onto the shift
shaft, be sure that the center of the shift pedal
is about 5.1 mm (0.2 in) a above the top of the
footrest.
4 - 88
ENG
New
10 Nm (1.0 m · kg, 7.2 ft · lb)
10 Nm (1.0 m · kg, 7.2 ft · lb)
12 Nm (1.2 m · kg, 8.7 ft · lb)