Publicité
2
FUSE INSPECTION
6. Install:
• Battery
• Battery band
7. Connect:
• Battery leads
CAUTION:
First, connect the positive lead 1, then the
negative lead 2.
8. Check:
• Battery terminals
9. Lubricate:
• Battery terminal
10. Install:
• Seat
EAS00181
FUSE INSPECTION
CAUTION:
To avoid a short circuit, always set the
main switch to "OFF" when checking or
replacing a fuse.
1. Remove:
• Seat
• Fuse cover
2. Check:
• Continuity
1
Checking steps:
• Remove the fuse 1.
• Connect the pocket tester to the fuse and
check the continuity.
NOTE:
Set the pocket tester selector to "Ω × 1".
• If the pocket tester indicates "∞", replace
the fuse.
2 Reserve fuse
3 - 56
(to the battery terminals)
Dirt → Clean with a wire brush.
Loose connection → Connect properly.
Recommended lubricant:
Lithium soap base grease
Pocket tester:
YU-3112-C/90890-03112
INSP
ADJ
Publicité
