GRAUPNER Heim Eurocopter Bo 105 CBS Mode D'emploi page 43

Contents
• Foreword .............................................
• Warning notes
.........................................
• Accessories, extra items required
• 1. Assembling the model
1.1 Preparation, explanatory notes
•
1.2 Preparing the skid landing gear
•
1.3 Installing the skid landing gear .........................
•
1.4 Installing the mechanics
•
1.5 Attaching the upper fuselage fairing .....................
•
1.6 Tail rotor .........................................
•
1.7 Stabiliser panels
•
1.8 Tailskid ..........................................
•
1.9 Tail cap ..........................................
•
1.10 Installing the silencer ...............................
•
1.11 Attaching the plastic parts: access hatches, windows etc... ....
•
1.12 Exhaust pipes ....................................
•
1.13 Applying the decal sheet decals .......................
•
1.14 Receiver aerial ....................................
•
1.15 Centre of Gravity ..................................
•
• 2. Setting up ...........................................
• 3. Final checks before the first flight
• 4. Maintenance
• 5. Fitting the starter adaptor ................................
• 6. Adjustments during the first flight, blade tracking
Notes on adjusting the motor .............................
•
• 7. General safety measures ................................
• 8. Some basic helicopter terminology .........................
The instructions
We have invested considerable effort in producing these instructions, with the aim of ensuring
that your model helicopter will fly reliably and safely.
Please take the trouble to follow the instructions step by step, exactly as described, as this
guarantees a successful outcome. This applies to you whether you are a relative beginner or an
experienced expert.
• Certain sections of the model are supplied pre-assembled, but they still need to be checked
and adjusted before use. It is entirely up to the modeller to ensure that all screws and other
joints are correctly seated and tight, and that all adjustments and set-up procedures are
completed correctly.
• The comprehensive illustrations show how the model is constructed; be sure to read the
instructions which accompany the drawings.
• All the joints marked with this symbol
e.g. Order No. 952, or bearing retainer fluid, Order No. 951. Remove all traces of grease
from the joint surfaces before applying the fluid.
...........................
.................................
.............................
..................................
.........................
........................................
Bo 105
........................
........................
..............
need to be secured with thread-lock fluid,
5
®
CBS
P.2
P.3
P.6
P.7
P.7
P.7
P.8
P.11
P.15
P.18
P.22
P.24
P.24
P.25
P.25
P.27
P.27
P.28
P.28
P.29
P.32
P.32
P.32
P.33
P.34
P.35
P.36