GRAUPNER Heim Eurocopter Bo 105 CBS Mode D'emploi page 49

®
Bo 105 CBS
1.4 Installing the mechanics
1.4.1 Preparing the mechanics supports
Apply UHU plus endfest 300 to two captive nuts and press them into the underside of the rear
mechanics support 6 (see illustration), and allow the epoxy to cure fully. You can speed up this
process considerably by applying heat (e.g. using a heat-gun).
Mount two brackets with inserts on bulkheads 2 and 3 as shown in the illustration, taking care to
fit them the right way round.
11