Keysight U3606B Mode D'emploi page 91

Triggering the Multimeter
The U3606B triggering system allows you to generate triggers either
automatically or manually via the [Trig] key on the front panel or the *TRG
command via the remote interface.
From the front panel (local interface), the multimeter always auto-triggers by
default. Auto triggering takes continuous readings at the fastest rate possible for
the selected measurement configuration.
You can enable the single trigger function to manually trigger the U3606B
readings (see
From the remote interface, triggering the U3606B is a three-step process:
1 Configure the U3606B for measurement by selecting the function, range,
2 Specify the U3606B trigger source. The U3606B will accept a software (bus)
3 Ensure that the U3606B is ready to accept a trigger from the specified source
See
source.
Keysight U3606B User's Guide
page 92).
resolution, and so on.
command or an immediate (continuous) trigger.
(called the "wait-for-trigger" state).
page 93 for more information on the software (bus) or immediate triggering
Operation and Features 2
91