Keysight U3606B Mode D'emploi page 157

Press [ ] or [ ] to change the ramp signal amplitude end position.
Press [ ] or [ ] until the cursor is position on the ramp signal number of steps.
Press [ ] or [ ] to change the number of steps for the ramp signal to increment
from zero to the amplitude end position.
– The increment of each step in the ramp signal will be the amplitude end
NOTE
– The ramp dwelling time selected will be fastest of the instrument output
Keysight U3606B User's Guide
CV/CC ramp signal parameters
Amplitude end position
(NN.NNN V or N.NNNN A)
position divided by the number of steps. For example, a 15 V amplitude end
position divided by 100 steps gives an increment of 0.15 V per step.
capability (typically ~100 ms per step).
System-Related Operation
Ramp signal range
Number of
steps (NNNNN)
4
157