Keysight U3606B Mode D'emploi page 161

Connecting to a remote interface
Press [ ] or [ ] to change the remote interface connection (GPib, U-CdC, or
U-tMC).
To change the GPIB address, press [ ] or [ ] until the menu item "GPiB" is
flashing.
Press [ ] to position the cursor on the GPIB address number. Use the directional
keys to select an appropriate GPIB address from 1 to 30.
See
NOTE
remote interface connections.
Configuring the beeper
Normally, the U3606B beeps whenever certain conditions are met (for example,
the U3606B beeps when a stable reading is captured in reading hold mode). The
beep driving frequency is set to "3840 Hz" by default, but may be disabled
through the front panel.
When the beep driving frequency is set to "2400 Hz" or "3840 Hz", a single beep
occurs for the following cases (turning the beeper "oFF" disables the beep for the
following cases):
– When a new minimum (Min) or maximum (Max) value is stored.
– When a new stable reading is updated on display for hold operation.
Keysight U3606B User's Guide
"Remote Operation" on page 167 for more information on the available
System-Related Operation 4
161