4 Loosen the top screws with a slotted screw driver and connect the rear output
Do not use the shield as one of the sensing conductors. Ground the shield at the
U3606B end only. The other end of the shield should be left unconnected.
Observe the polarity when connecting the sensing leads to the load. You can
connect the output leads to either one of the two + or – terminals. They are
internally shorted.
The sensing outputs (S+ and S–) must not be left unconnected. It must be
NOTE
connected locally
5 Tighten the top screws of the rear output terminal block to secure firmly the
6 Place the rear output terminal block back in place and tighten the two captive
Keysight U3606B User's Guide
terminal block sensing (S+ and S–) and output (+ and –) terminals to the load
as shown in
Figure 3-1
(Figure
sensing and output connections.
screws again.
using a shielded two-wire cable.
3-2) or remotely
(Figure
DC Power Supply Operation
3-1).
3
137