Keysight U3606B Mode D'emploi page 128

3 DC Power Supply Operation
– The typical ramp dwelling time per step in the U3606B is measured at
NOTE
– If you want to adjust the ramp signal parameters, press [Shift] > [Utility] to
– The maximum amplitude end position will be limited by the range and
Scan signal
A typical scan signal length is based on the following parameters:
– the amplitude end position,
– the number of steps required to reach the amplitude end position, and
– the dwelling time length for each step.
You can configure the scan signal amplitude end position, number of steps, and
dwelling time length in the Utility menu.
The total dwell time will increase with respect to the number of steps and the scan
dwell time per step selected. The scan dwell time is defined as the length of time
the scan signal will "dwell" in the present step before incrementing to the next
step.
128
100 ms. A longer delay time should be expected if a high number of steps is
programmed. As an example, a 1000 step ramp signal will yield a 200
seconds (1000 × 100 ms × 2) total dwelling time.
access the Utility menu.
function (CV or CC) selected.
Amplitude
(V/A)
Amplitude
end position
0
Number
of steps
Scan dwelling time
Total dwelling time
Keysight U3606B User's Guide
Time (t)