Keysight U3606B Mode D'emploi page 39

Table 1-4 Keypad descriptions (continued)
Legend
[a] The voltage path is the default path when you select the frequency measurement function. To switch to the current path for frequency, pulse
width, and duty cycle measurements, first press [
[b] The refresh hold variation and threshold values can be configured through the Utility menu.
[c] The continuity and diode test functions have a fixed 4½ digit resolution. Capacitance measurement is fixed to 3½ digit resolution.
[d] The sweep functions can only be accessed when the U3606B is in constant voltage or constant current operation. You cannot access the
sweep functions while the U3606B is in square-wave output operation.
[e] The over-current and over-voltage protection features are only active when the output protection state is enabled.
[f] You can only change the range when the instrument output is in the "standby" state (the SBY annunciator is illuminated).
Keysight U3606B User's Guide
Description
Press [Shift] > [Limit] to set the over-current limit value for the CV output or the
over-voltage limit value for the CC output.
Press [Shift] > [Protect] to set the over-current protection value for the CV
output or the over-voltage protection value for the CC output
– CV operation: Press [Shift] > [Range] to toggle between range S1 (30 V/1 A),
range S2 (8 V/3 A), range S2m (1000 mV/3 A), or S1S2 (autoranging)
– CC operation: Press [Shift] > [Range] to toggle between range S1 (30 V/1 A),
range S1m (30 V/100 mA), range S2 (8 V/3 A), or S1S2 (autoranging)
OU T
Press [ ] to toggle between source output (OUT) and source standby (SBY).
SBY
Press [Shift] > [EXT] to enable remote sensing.
I ], then press [Hz ms %].
Introduction 1
[e]
.
[f]
.
[f]
.
39