Toyota 02-8FGF15 Manuel De L'opérateur page 79

01_A5028-0EA04_En.fm Page 86 Monday, June 27, 2011 10:08 AM
DANGER!
Risk of personal injury or material damage.
There may be special areas where the radio waves from the T.W.I.S.
may cause unforeseen risks.
If there are, in an area, special instructions for the use of r
cell phones or suchlike, then these instructions must be followed.
WARNINGS!
Risk of damage to the T.W.I.S.
The unit must not, under any circumstances, be opened.
Switching on and off must only be done in a de-energised state.
Only personnel that have adequate training may install or repair the product.
Note!
All connections in the truck must be made according to the recommended
instructions for the connection of extra equipment.
Refer to the Service Manual for the truck in question.
STARTING THE TRUCK
Insert the ignition key
Turn the key to the [ON] position (1).
Enter your PIN code and press the green
key [1] on keypad (2) to valid.
Turn the key to the [START] position (3).
The engine starts.
WARNINGS!
Wait until motor preheating ends
before starting (light off).
STOP THE TRUCK
Press the red key [0] on keypad (2)
or
turn the key to the [OFF] position (4).
The engine stops.
en-78
1
ON
2
3
ON
START
4
OFF
ON
START
OPTIMAX SPECIFICATIONS
AUTOMATIC LIFT CONTROL OR A.L.C.
Principle:
to the movement of the lever and allows to manage the speed of
It is not necessary to use the accelerator pedal to handle these speeds.
For operator safety, the transmission is cut off when using the ALC.
CAUTION
the truck.
Note:
With the function A.L.C. the engine speed does not reach its maximum.
pedal, making sure to press the approach pedal if you don't want the truck move.
speed proportionally
ansmission and moves