Turn Signal Switch; Control Lever; Horn Button - Toyota 02-8FGF15 Manuel De L'opérateur

01_A5028-0EA04_En.fm 22 ページ ２０１２年１２月６日 木曜日 午後１２時４２分
(1)
(2)
(1) Forward
(2) Reverse
en-22

Turn signal switch

Makes the turn signal lamps blink
Left turn ................................... Push forward
Right turn ................................ Pull backward
The signal switch will operate when the igni-
tion switch is ON.
The turn signal lever returns automatically to
the original position after making a direction
change.

Control lever

Lever for shifting between forward and
reverse.
Forward .................................... Push forward
Reverse..................................... Pull backward
The neutral position is halfway between the forward
and reverse position.
Note:
After the OPS System operates, return the
accelerator pedal to its fully released position
and set the control lever to the neutral position,
and sit on the seat to restart driving. (Even
though the operator sits on the seat, driving is
impossible unless the control lever is in the
neutral position.)
Caution Caution
The engine cannot be started unless the con-
trol lever is in the neutral position.
Stop the vehicle before shifting between for-
ward and reverse direction.
(1)
(1) Push
Torque converter interlock function
(Option)
If you switch the control lever direction to
something other than the current travel direc-
tion while moving at high speed, this function
electrically disengages the drive and sets the
torque converter to neutral. Once the speed
drops below the set speed while running in
neutral, the travel direction is automatically
switched.
To change travel direction, operate the control
lever after travel speed is reduced sufficiently.
Ask your Toyota dealer for changing speed set-
ting.
Caution Caution
• When the interlock has engaged, release
the accelerator pedal and use the brake
pedal to reduce speed. After the vehicle
has stopped moving, slowly press the
accelerator pedal down to start moving
again. Disengaging the interlock while
the accelerator pedal is pressed down
could result in wheel spin.
• Do not perform Forward or Backward
operation on slopes. If control lever is
operated on a down slope, torque con-
verter interlock function may not oper-
ate correctly.

Horn button

Press the button in the center of the steering
wheel to sound the horn.
The horn will sound even when the ignition
switch is OFF.