Switches And Levers; Ignition Switch - Toyota 02-8FGF15 Manuel De L'opérateur

01_A5028-0EA04_En.fm 21 ページ ２０１２年１２月６日 木曜日 午後１２時４２分

SWITCHES AND LEVERS

Ignition switch

 [OFF] ....... Engine stop position.
Key insertion and withdrawal
are performed in this position.
I
[ON]......... Engine operation position.
Located one position clock-
wise from  [OFF] position.
The intake heater is preheated before starting
in the diesel models.
START ............ Engine, start position. Located
one position clockwise from
the I [ON] position.
After the engine starts, release the key and it
will return to the I [ON] position automatically.
In the torque converter model, the engine does
not start unless the control lever is set in the
neutral position.
Caution Caution
• Never operate the ignition switch with-
out first sitting on the seat. Otherwise,
the forklift could start to move uncon-
trolled, causing an accident.
• When the OPS lamp is on, return each
lever to the neutral position and sit on
the seat.
Then confirm that the lamp has gone off.
• Do not leave the switch in the [ON] posi-
tion when the engine is stopped. It may
cause over discharge of the battery.
• Do not turn the switch to the START
position while the engine is running.
• For the sake of safety it is recommended
to always start the engine of a vehicle
with the transmission gear shift lever
shifted in the neutral position.
• Do not operate the starter motor for
more than 30 seconds continuously.
Return the switch to the [OFF] position
and wait at least 30 seconds prior to
attempting restart.
• In case of the anti-restart ignition switch
(optionally available), be sure to shift the
switch to the [OFF] position before
attempting to start the engine again.
(1)
(2)
(1) Left turn
(2) Right turn
• With the ignition switch OFF (engine
off), the forks will not lower even if the
lift lever is operated. However, if you sit
in the seat and turn on the ignition
switch, you can lower the forks. (Except
mini lever models) Do not operate the lift
lever before getting on the vehicle and
starting up the engine. (key-off, lift
locked)
• If the diagnosis lamp does not go off even
when the operator sits on the seat, the
battery power may be low. In such a
case, do not drive the vehicle until the
lamp goes off, otherwise the vehicle may
not operate correctly. If you are obliged
to drive the vehicle, do so with the
utmost care. Also, stop driving and ask a
Toyota dealer for inspection if the lamp
does not go off 1-2 minutes after the
engine starts, or when you race the
engine for a while. (For diesel vehicles,
the diagnosis lamp may be on for a while
to warm up the engine after cold start-
ing. This is, however, not an engine mal-
function or failure.)
Integrated light and turn signal
switch
This two-position switch serves as both a light
switch and turn signal switch.
Light control switch
Irrespective of a ignition switch position, this
switch allows you to turn on and off the lights.
This switch has two positions. With the switch
at each position, the light comes on as shown
below.
Lamp name Step 1 Step 2

Head lamps
−
Side clearance lamps, tail lamps
 
(Option)
 
Meter illumination lamp
Caution Caution
Do not keep lights such as head lights on for
a long period when the engine is stopped. It
may cause over discharge of the battery and
make engine starting impossible.
en-21
en